Woodstock - W1218A

Below are all the different types of Woodstock. Select the device of your choice, to download the manual

Contents

Small Tip ROTACATOR ADJUSTMENT JIG FOR PLANERS Preparation 1 DISCONNECT PLANER FROM POWER 2 Set knives in cutterhead with factory knife setting jig 3 Adjust opening between table and headstock to approximately 4 This gives you enough space to work with the Rotacator Adjusting Planer Bed Parallel to Planer Knives 1 Insert the large tip into the Rotacator 2 Rotate dial indicator to Up Reading position see Figure 1 3 Place dial indicator between table and cutterhead at one end of the cutterhead Up Reading Position 4 Gradually reduce opening space until the Rotacator plunger is slightly depressed by one of the knives Make sure that knife is at the lowest point of its cutting arc 5 Note the reading on the dial indicator face 6 ...