Pelco - EPSPWR-300

Below are all the different types of Pelco. Select the device of your choice, to download the manual

Contents

C1638M 4 05 EPSPWR 300 Power Supply Replacement The EPSPWR 300 power supply can be used to replace a failed power supply in the EPS5000 300 You can easily replace either of the two power supplies in the EPS5000 300 in case of failure You will know if there is a problem with a power supply because the blue Pelco badge on the front panel will turn off Before replacing a power supply check the fuse It can be replaced easily with the supplied spare If the fuse is not the problem then follow these steps and refer to Figure 2 to replace the power supply 1 2 3 4 5 6 7 8 Disconnect the over molded cable and the power cord from the failed power supply Unscrew both thumbscrews of the failed power supply Remove the power supply Insert ...