Woodstock - Planer

Below are all the different types of Woodstock. Select the device of your choice, to download the manual

Contents

ROTACATOR PLANER ADJUSTMENT JIG INSTRUCTIONS FOR USE Preparation 1 Disconnect planer from power source before performing any of these adjustments 2 Confirm that the knives are properly set within the cutterhead using the factory knife setting jig 3 Adjust depth of cut so that the cutterhead is approximately 4 above the table 4 Insert the flat point screw tip into the Rotacator Adjusting Planer Bed Parallel to Planer Knives 1 Rotate dial indicator to Up reading position see Figure 1 2 Place the dial indicator between the bed and cutterhead at one end of the cutterhead 3 Gradually reduce the depth of cut until the dial indicator s plunger is slightly depressed by one of the knives Make sure that the knife is at the lowest point of its ...